Specifications

Security Systems
Grasbrunn
05-February-2015
Page 37 of 38
• Configuring an I-Frame Quality value of 4 for XFM4 encoder modules was
set incorrectly as 0 on the device. This has been corrected.
• Displaying Image panes in Operator Client for DiBos and BRS has been stabilized.
• Encoder and decoder connections used to require having the same password on both devices.
This has been resolved to work now as well with different passwords.
• Image quality of exports in ASF format has been improved for both HD and SD cameras.
• In large systems it could take up to one minute until a device is shown as disconnected in case of
network disconnect. This has been improved to take usually less than 15 seconds.
• In rare situations, sequences with Bosch Recording Station cameras would run into displaying
issues. This has been resolved.
• In rare situations, the connection status of an encoder or an IP camera would not be updated
correctly after the device was without power.
• In some situations, changes to Special Days for recording settings would not be updated on
encoders and cameras recording with VRM.
• IntuiKey keyboard sometimes did not offer PTZ control instantly when selecting a PTZ camera.
This has been resolved.
• Performance for Operator Client logon screen to initially appear has been improved.
• Playback for VRM has been stabilized for non-responsive iSCSI targets and has been improved
to allow frequent forward and backward playback operations.
• PTZ locking can now lock multiple PTZ cameras at the same time.
• When replacing an MPEG-4 device with an H.264 device under the same IP address, now
MPEG-4 and H.264 recordings can be played back in the same timeline.
• When a decoder connection has been lost, in some rare cases the video image was not restored
on the monitor automatically. This has been resolved.
• When configuring IP cameras of the ARM device family, Configuration Client now correctly
reflects that one BP+ stream is possible.
• When jumping to the newest and oldest recording, the Image pane is refreshed now reliably.
• When scanning VRMs in Config Client, response time has been significantly improved. VRM
cannot be scanned in multicast.
Known issues in version 3.0
• A snapshot or print-out of a DiBos or Bosch Recording Station live image has the record date of
Jan 1, 2000.
• Cameras configured in sequences are shown on Analog Monitors independently of the user
permissions for this camera.
• Find Video By Event will not display possible results if detailed filtering criteria is used. Best
search by defining a time span only.
• Frequent network losses between Central Server and DiBos or Bosch Recording Station may
result in alarms from DiBos or Bosch Recording Station no longer being transmitted.
• In large configurations with 2000 cameras, saving the configuration in relationship with detailed
permission settings can take up to 10 seconds in some situations.
• In order to verify the authenticity of video data, an Operator must specify a start and end time.
Verify Authenticity checks against manipulation of video data. Verify Authenticity is not supported
for Alarm Image panes.
• In some rare occasions, Operator Clients have to be started manually after No-Touch-
Deployment.