LDS Robotic Vacuum Cleaner with Docking Station Operation Manual M790 20200408
TABLE OF CONTENTS SAFETY INSTRUCTIONS ---------------------------------------------------- 2 * SAFETY INSTRUCTIONS * WARNING * BATTERY AND RECHARGING INSTRUCTIONS SPECIAL FEATURES --------------------------------------------------------- 8 MAJOR COMPONENTS AND ATTACHMENTS ------------------------- 8 M790 OVERVIEW -------------------------------------------------------------- 9 INSTALLATION GUIDE ------------------------------------------------------ 10 * Installing and Removing Side Brush * Recharging Batt
SAFETY INSTRUCTIONS Please read the safety instructions in the Operation Manual before operating M790 and keep this manual handy for your future reference. Observe the basic safety rules to prevent any occurrence of fire, electric shock and personal injury. SAFETY INSTRUCTIONS: 1. Please read the Operation Manual before operating M790. 2. Do not operate M790 outdoors. 3. Before starting M790, be sure to install M790 dust bin filter properly in case of any damage of M790. 4.
SAFETY INSTRUCTIONS damaged. 10. If M790 malfunctions or is damaged by force, do not operate unit, regardless of the cause. Please call your local dealer for service information. 11. Turn off the power and remove the battery from M790 if the unit will not in use for a long period of time. 12.
SAFETY INSTRUCTIONS WARNING: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.
SAFETY INSTRUCTIONS RF Exposure Warning: This Wireless LAN ( local area network)device has been evaluated under FCC Bulletin OET 65 and found compliant to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF exposure from radio frequency devices. The radiated output power of this Wireless LAN device is far below the FCC radio frequency exposure limits.
SAFETY INSTRUCTIONS BATTERY AND RECHARGING INSTRUCTIONS: 1. Please apply the same model’s battery (INR18650 3S2P 10.95V 5200mAh) and adaptor (PA-124018XX 20V 1200mA) as equipped with the packing. 2. The external flexible cable or cord of this adaptor cannot be replaced; if the cord is damaged, the adaptor shall be scrapped. 3. When placing the batteries into the reservoir, please be sure that the polarity of the batteries matches with the indication marked inside the battery reservoir.
SAFETY INSTRUCTIONS 11. If M790 requires cleaning, unplug the adaptor, switch off the unit and take out the battery. 12. The battery must be removed from the appliance before it is scrapped. 13. The appliance must be disconnected from the supply mains when removing the battery. 14. To extend the battery life, we suggest to keep the product being always charged when not in use. Recharge M790 as soon as possible following use; waiting several days can damage the battery 15.
SPECIAL FEATURES Congratulations on purchasing M790, the best LDS Robotic Vacuum Cleaner. M790 is a revolutionary LDS Robotic Vacuum Cleaner With Docking Station is equipped with an intelligent mapping system and powerful suction system for effectively cleaning your assigned cleaning tasks. M790 also supports APP control which can create the normal zones, prohibited zones, double clean zones, schedule, etc. It helps you customize your preferred cleaning task. M790 is definitely a household helper.
M790 OVERVIEW Top Cover(Du st bin and power switch inside) Lidar Control Panel Power Indicator Bumper Contact Plates Contact Plates Front Small Wheel Battery Side Brush Side Brush Anti-Cliff Sensor Anti-Cliff Sensor Intake Valve & Brush Roll Wheel Cover Left and Right Wheels Speaker Heat Vent 9
INSTALLATION GUIDE Installing and Removing Side Brush: To install: Push the brush directly onto the holder.(Fig. 1) To remove: Hold two opposite sides of the brush as shown in Fig. 2, and evenly pull upward to remove the brush. PULL UP! Side brush holder PRESS CLICK! Fig. 1 Fig.
INSTALLATION GUIDE Recharging Battery: 1. Before charging, please check if the battery is properly mounted and turn on the power switch. Power Switch to ” I ” 2. Two ways to charge the battery: A. Manual charge: Push the M790 onto the docking station and make sure the contact points at the bottom of the unit are contacted with the contact plate at the docking station.
GENERAL OPERATION Preparation for Operation: 1. Install the side brushes and install the battery according to the manual. 2. Turn on the power switch under the top cover of unit and charge the battery for 4~6 hours prior to the first operation. Power Switch to ” I ” 3. To ensure the best efficiency of the unit, first is to remove clothes, paper, cable, extension cable scattered on the floor, roll up the curtains and drapes if any to avert the possible accident.
GENERAL OPERATION Control Panel: Wifi Indicator Spot clean Power Indicator Warning Indicator Power Button Docking Button Control Panel: Description Button Power Button Turn on/Off, Start / Pause / Stop Cleaning Docking Button Start / Pause Docking Spot Clean Start cleaning in a 1.8M*1.8M area Indicator Description: Description Indicator Warning Indicator Power Indicator Wifi Indicator The indicator will light on with the following conditions: 1.
GENERAL OPERATION Start: Make sure the M790 is already charged onto the docking station with the adaptor plug-in then press the power button “ ” on the panel for 3 seconds to power on M790 and waiting for 20 seconds to complete the initiation process. 1. Clean: In standby mode, press the power button “ ” , the cleaner will start a total cleaning until it finished or press the button again. The cleaner will enter the sleeping mode (all indicators light-off) if no operation in 10 minutes.
GENERAL OPERATION For more intelligent cleaning functions, please download our APP and check our Quick Start Guide to experience more immersive settings. APP download and install (Please refer to our Quick Start Guide) : Support Android 7.
CLEANING AND MAINTENANCE Maintenance Method: The operation and maintenance of the M790 is very simple. After each use, clean any dirt left behind on the dust bin and filter. It is not necessary to clean the intake after every use. Cleaning Dust Bin: 1. Lift the cover from "A" position to open the top cover of the cleaner. A 2. Pull up the grip and take out the dust bin from the cleaner.
CLEANING AND MAINTENANCE 3. Open the upper cover of the dust bin. Side buckle 4. Lift up and take out the filter. 5. Throw away the dust and dirt from the dust bin.
CLEANING AND MAINTENANCE 6. Rinse the dust bin with tap water and drain completely. It is not necessary to wash every time. Please do not put it into the washing machine to do the cleaning. 7. Periodically clean the filter with a soft bristle brush. 8. Once dry, reinstall the filter and close the dust bin lid. Side buckle (Make sure the cover firmly closed) 9. Place dust bin and top cover back in unit.
CLEANING AND MAINTENANCE Cleaning Side Brushes: 1. After being used for a period of time, the brushes need to be replaced for working more effectively. 2. Turn off the power, place bottom of the cleaner upward on a flat surface. Hold two opposite sides of the brush (see diagram below), and evenly pull upward to remove the brush. 3. The side brushes can be rinsed and if they become crooked, you can soak them in hot water to make them recover to the original shape. Install the brushes back after cleaning.
CLEANING AND MAINTENANCE Cleaning Brush Roll & Inlet: 1 Removable VAC-SWEPT 2 3 Put the brush roll back after cleaning.
CLEANING AND MAINTENANCE Battery Installation and Removal: 1. Turn off the power switch before installing the battery. 2. The method of replacing battery: Loosing screws from the bottom case and disconnect the battery and install the new battery in the battery compartment with correct connection and screw it back to the bottom housing. Be sure to orient the battery contacts with those of the unit.
TROUBLE SHOOTING Problem Possible Cause Solution 1. Install the battery according to the manual. 2. Charge the battery according to the manual. 1 1. Battery is not installed Power switch on. correctly. Press power key but no 2. Very low battery. LED display shown. 2 Vacuum on but can not collect dirt or hair. 1. The dustbin is full. 2. The filter is not installed correctly. 1. Clean the dustbin. 2. Re-install the filter correctly. 3 Side brush becomes crooked. Doesn't sweep well.
SPECIFICATIONS M790 Rating Voltage 10.95V Power 29Watt Li-ion Battery Type rechargeable battery Battery Capacity 5200mAh Charging time 4~6 hours Working time 120 +-/10min Operating temp 5℃~45℃ Operating humidity ≦80%RH Noise ≦65dB Weight Dimension 3.5kg ∅: 360*93mm Accessory Adaptor 20V/1.2A Docking Station 20V/1.
This device can be used in all EU Member States. The frequency bands and the maximum radio frequency emission power in which this device operates are as follows: Model WiFi Frequency Range Antenna Gain Antenn Configuration Transmitted power M790 2.412-2.472GHz 4.6 dBi Single Transmitting ≤20dBm Hereby, Matsutek, declares that this Robotic Vacuum Cleaner is in compliance with the essential requirements and other relevant provisions of RE Directive 2014/53/EU.
