I . SPECIFICATIONS Model/Name LBD6 Donut machine Voltage AC 110 V / 60 Hz AC 220 V / 50Hz Heating Power 2 KW Weight 19 KG Donut Diameter 20~40 MM Machine's Size 500*550*450MM II. IMPORTANT SAFEGUARDS 1. Make sure that your power supply matches with the power that marked on the product. The deviation is under 10%. 2. Before connect the power, please connect the ground wire firstly. ! It is high power (2 KW) equipment, connect a Current safety device before use it. 3.
III. ILLUSTRATIONS ! Usually,the machine is assembled already for this model. Instructions for switch of Operating S [ Heat Lamp ] When heating tube is working,it will light. [Counter Reset] You can reset the counter vie it. [ TEMP-C] When actual temperature of the oil is different from the set temperature,you can adjust by it. [ TEMP Set+ ] Increase the heating temperature. [ TEMP Set- ] Decrease the heating temperature. [ Time + ] Increasing frying time. [ Time - ] Decreasing frying time.
IV. OPERATING INSTRUCTIONS 1. Install all parts of the machine and clean it. ! Make sure thermostat is off before press power switch. 2. Connect power including ground wire. Make sure that power requirements of the machine do match the power source as specified on machine's data plate. 3. Have all material prepared and pulling oil into oil tank. ! Danger of fire exists if no oil or water in oil tank. DO NOT have machine on heating condition when tank is dry. ! Mind the heat oil and don't get a burn. 4.
is to your desired value, thermostat will be off by itself and heating tube will stop working. Thermostat indicator is off at the same time. When oil's temperature degree decreases, thermostat can connect power automatically and thermostat indicator start working again. This will circulate to ensure temperature is within the temperature range you set. E. Pull the pre-dought into container. F. Press switch Drop to have dought from container.Dought will be fried in oil tank. G.
