User's Manual

Confidential Document | Page 6 of 10
4 Interfaces
The module main interface is USB for communication configuration.
4.1 USB Interface and Powering Options
The board’s main interfaces are USB 2.0 in high-speed mode (480Mbit) and power supply. Both can be
provided by an onboard USB type-C connector.
Connector and powering options:
Capability \ Model
VMPRO19CB4
Connector types
USB type-C
Power Supply Connector
USB type-C
Voltage supply
5V +/-10%
Power Consumption
0.4-0.9A
5 Software Installation
VMAKERPROUWB is to be operated with dedicated SW per model, project, final product and the specific
platform and OS (Windows, Android etc). The relevant SW and instructions will be given per device and
project, separately from this manual.
General SW high-levels:
• The software contains a driver through which the application software communicates with
VMAKERPROUWB device.
• The driver translates the commands into VMAKERPROUWB’s actions.
• Moreover, the driver is in charge of enforcing certain regulatory restrictions.
• The user is required to communicate with the VMAKERPROUWB device only through the driver
using the provided API.
6 Mechanical placement
The VMAKERPROUWB are provided as bare boards or with an optional mechanical housing and case. The
mounting instructions shall be provided per specific product or module. In the case that a proprietary case
is used, make sure that the front cover is nonmetallic (e.g. plastic) and preferably thin (not exceeding 2
mm).