Installation & Assembly

Sku Number: X0114
X0115
LED UNDERCABINET LIGHT
Model Number: U4634
U4632
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Safety Glasses, Ladder, Wire Stripper.
Page 2 of 4
SAFETY INFORMATION
PREPARATION
ASSEMBLY INSTRUCTIONS
• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
•
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching
off circuit breaker).
• Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
Important to know
Important safety instructions
Installation Steps
Note:
1. Find a suitable location to mount the fixture, the mounting surface should be a minimum of 1/2” thick and
approximately 3” distance for linking cord should be allowed at both ends of fixtures.
2. Carefully plan out your installation prior to actually securing your cabinet light fixture to the mounting
surface. Make sure that your 11 ft. power adaptor will reach the nearest electrical outlet.
1. Read all instructions carefully before installation and operation.
2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified
electrician.
3. Maximum number of LED cabinet lighting fixtures per run should not exceed power supply wattage rating.
(Maximum 24W)
4. Do not use in wet locations, use indoors only.
5. Non-replaceable LEDs.
6. LED light output is strong enough to injure human eyes. Precautions must be taken to prevent looking directly at the
LEDs with unaided eyes.
7. Specification:
NO
.
1
2
20
1.25
Dimension(inch
)
Item #.
X0115
12 1.25
X0114
A
B
C
5.1
0.4
0.4
Watts
7.6
A
B
C
1. Never use with an extension cord unless plug can be fully inserted.
2. Do not alter the plug.
3. Do not attempt to install fixture while plugged in.