Installation & Assembly

Operation
Wave hand under sensor once to
turn light on and off.
TURNING LIGHTS ON, OFF
Wave hand under sensor twice,
Light will flash, then gradually
dim-to-off in 1 minute.
DIMMING LIGHTS
Hold hand under sensor to adjust
brightness.
1x
2x
ACTIVATING SAFE EXIT
NOTE: Detection zone is within 4" or 8" distance from the sensor.
160225
Choose an option by sliding the switch on the surface of the sensor control. (See Fig.9 ).
When the switch is set to “ ”, the sensor is deactivated.
When the switch is set to “ ”, the sensor 's active detection range is 4" below the fixture.
When the switch is set to “ ”, the sensor 's active detection range is 8" below the fixture.
NOTE: This under cabinet light fixture has a memory function.
* If the fixture is switched off, it will return to the same level of
brightness when switched on again.
Page 4 / 5
Fig.9
Function and Operation
Lock
8"
4"
Sensor Control
Label
Power Label: Hardware pack includes a "Power" label
sticker.This can be applied to the cabinet
surface above the IR detection area to serve
as a reminder for motion sensor control
location.
Cleaning instructions
Your fixture is made from quality materials that will last for
many years with minimum care. When cleaning, make sure
you have unplugged your fixture, and have allowed
sufficient time for the unit to cool to room temperature. You
should clean the housing and lens using a damp soft cloth.
You should plug your fixture back in only after the fixture
has thoroughly dried.