Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
W0338
1. Thread two fixture mounting screws (B)
through the mounting plate (A),
and then secure with two lock nuts (E).
Adjust the length of the fixture
mounting screws (D) if necessary .
2. Attach the mounting plate (A) to the
outlet box by using two mounting
screws (B).
3. Pull out the source wires from the
outlet box. Make wire connections using wire
connectors (C) as follow:
---Connect the hot wire (black insulation) from the fixture
to the black wire from the power source.
---Connect the neutral wire (white insulation) from the fixture
to the white wire from the power source.
---Attach the fixture ground wire (green insulation or bare wire)
to the mounting plate (A) with the green ground screw, then
connect it to the house ground wire with the wire connector (C).
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate (A) by inserting two fixture
mounting screws (B), then secure it with two ball nuts (F).
5. Attach the glass shade to fixture, then secure it with support rods (G).
6. Install bulb(not included). Check relamping label at socket area or packaging for
maximum allowed wattage.
190418
Mounting Screw (B)
Mounting Plate (A)
Green Ground Screw
House Ground Wire
Fixture Ground Wire
Outlet Box
Fixture Ground Screw (D)
Lock Nut (E)
Wire Connector (C)
Fixture Wire
Back Plate
Ball Nut (F)
Support Rod (G)
Glass Shade
Fixture
Bulb Type A Max.100W
(not included)
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
T
Turn off the power at fuse or circuit box.
Installation Steps
Turn on the power at fuse or circuit box.
Mounting Plate (A) Fixture Mounting Screw (D)Wire Connector
(C) Lock Nut (E) Ball Nut (F) Support Rod (G)
Mounting Screw (B)