Installation Sheet

181126

Turn off the power at fuse or circuit box.

Turn on the power at fuse or circuit box.

Installation Steps

Fixture Mounting screw (E)

Mounting Screw (B) Green Grounding Screw (C)

Wire Connector (D)

Lock Nut (F)

Ball Nut (G)

Mounting plate (A)

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Mounting Hardware

6027MM (1 SET)

Glass Shade

10047CR (1PC)

1. Attach the mounting plate to the outlet box by using two mounting screws. Adjust fixture mounting screws-loosen the

nut, adjust length as necessary, and tighten back down.

2. Pull out the source wires from the outlex box. Make wire connections using wire connectors as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green

grounding screw, and then connect it to the house grounding wire with the wire connector.

Carefully put the wires back into the outlet box.

3. Attach the back plate to the mounting plate through screw holes as shown, and secure with ball nuts.

4. Install a bulb (not included). Check relamping label at socket area or packaging for maximun allowed wattage.

5. Attach the glass shade to the glass holder directly.