Installation Sheet

(3x12”)

Plug-in Installation

a. Feed the plug-in wire through the rods(L) based on the Height of the

fixture you want.

b. Take off the plug(M) on the back plate, let the plug-in wire through the

plug, plug hole and the strain relief(C).

c. Cut excess plug-in wire. Leave 10 inches from the back plate. Slit the

plug-in wire apart in 5 inches. Peel off insulation of the two wires in

5/8 inch.(See Fig.2)

d. Secure the threaded pipe of the rod with hex nut(D) as well as

washer(E).

e. Connect the wires:

1) The black wire from the back plate to the smooth wire (marked)

from the plug cord.

2) The white wire from the back plate to the ridged wire (unmarked)

from the plug cord.

3) Carefully put the wires back into the back plate.

f. Fasten the fixture body with four flat head screws.

g. Attach the rod strap(G) to the connected rod(L) at the bottom, then

secure it to the wall using dry wall screws.

Anchors for cement wall.

h. Install the shade with socket ring.

i. Install the bulb (not included,Medium base Max 100W)

Mounting Screw(A) Wire Connector(B) Strain Relief(C) Hex Nut(D) Washer(E) Anchor(F) Rod Strap(G) Dry Wall Screw(H)

Plug-in Wire

Rods(L)

Plug(K)

Strain Relief(C)