Installation Guide

190724
The following parts are available for re-order if damaged or missing.
A: 14-3/4"
B: 8-1/4"
C: 8"
Turn on the power at fuse or circuit box
Spare Parts List:
Mounting Hardware
6152MM (1 SET)
Glass Shade
9851CB (2 PCS)
Headless Screw (D)
Mounting Screw (B) Wire Connector (C)
Lock Nut (E)
Mounting plate (A)
Ball Nut (F)
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
---Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
---Attach the fixture ground wire (green insulation or bare wire) to the mounting plate (A) with the green ground
screw, then connect it to the house ground wire with the wire connectors (C).
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate (A) by inserting the headless screw (D), then secure it with the two ball
nuts (F).
5. Attach the glass shade onto the glass holder and tighten it with the socket ring.
6. Install two bulbs (not included). Check relamping label at socket area or packaging for maximum allowed wattage.