Installation Guide

2x
141205
Page 2
Turn on the power at fuse or circuit box.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually bare wire) to the cross bar with the green grounding screw. Then connect
it to the house grounding wire with a wire nut. If your outlet box does not have a house grounding wire, then wrap the
fixture grounding wire around the green grounding screw.
Carefully tuck the wires back into the outlet box.
4. Attach the back plate to the cross bar by inserting the long screws, then secure it with the ball nuts.
5. Attach the shade onto the bracket and secure it with the socket ring.
6. Install bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Function and Operation
Wave hand under sensor once to
turn light on and off.
Note: Detection zone is within 10cm
distance from the sensor.
TURNING LIGHTS ON, OFF.
ACTIVATING SLEEP FEATURE.
Wave hand under sensor twice. light
will flash, then gradually dim-to-off in
5 minute.
DIMMING LIGHTS
Hold hand under sensor to adjust
brightness.
1x
1. Remove and discard the stopper from the back plate.
Assembly Instructions:
Turn off the power at fuse or circuit box.
Option 2: (For Portable Use)
When power is first applied, the light will turn to high level brightness.