Installation Guide

ManualsBrandsVaxcel ManualsBathroom LightingVaxcel Lighting Elsa 3 Light Vanity Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0152

1. Remove the mounting plate from fixture by unscrewing two bolt nuts.

2. Fix the mounting plate to the wall.

a) For wooden material:

Attach the mounting plate to the outlet box by using two mounting screws, and then secure the dry wall screws

through the set holes to the wall.

b) For cement material:

Place the mounting plate to the outlet box and mark the target on the wall from the set hole for drilling two holes.

Remove the mounting plate from the outlet box. Thread the anchors into the holes, then attach the mounting plate

to the outlet box by using two mounting screws. Secure the dry wall screws through the set holes into the anchors.

141118

Mounting Screw (A)

Wire Nut (B)

Dry Wall

Screw (C)

Anchor (D)

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

House Grounding Wire

Fixture Grounding Wire

Mounting Plate

Green Grounding Screw

Bolt Nut

Mounting Screw (A)

Fixture Mounting

Screw

Socket

Fixture

Pure Shell(E)

Back Plate

Lock Nut

Set Hole

Anchor(D)

Wire Nut (B)

Dry Wall Screw(C)

Outlet Box

Bulb Type B Max.

60W (not included)

Summary of content (2 pages)

PAGE 1
W0152 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (included): Wire Nut (B) Mounting Screw (A) Dry Wall Screw (C) Anchor (D) Pure Shell(E) Wire Nut (B) Bulb Type B Max.
PAGE 2
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follow: ---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source. ---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green grounding screw.