Instructions / Assembly

Turn on the power at fuse or circuit box
Glass Panel
Fixture
Bottom Notch
Fig.1
Glass Panel
Fixture
Top Clip
Fig.2
Turn on the power at fuse or circuit box.
1. Turn off the power at the fuse or circuit box before starting installation.
2. Loosen the wire connector connected with the wires from photocell. (See Fig.3)
Note: Do not remove the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire connector (C): (See Fig.4)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the backplate of the fixture.
Photocell
White Wires From Photocell
Wire Connector
Wires From Fixture
White Pigtail
Red Wires From Photocell
Black wires From Photocell
Fig.3
Wires From Fixture
Wires From
Main Power
Wire Connector (C)
Pigtail
Fig.4
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
• Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with the green ground screw, then
connect it to the house ground wire with the wire connector (C).
Carefully put all of the wires back into the outlet box.
4. Attach the backplate of the fixture to the mounting plate unit (A) by aligning holes,
secure the two set screws (D) from the side hole of the backplate into the hole in
the side of the mounting plate unit (A).
Note: With silicone caulk compound, caulk completely around where the
backplate meets with the wall surface to prevent water from seeping into the
outlet box.
5. Take a glass panel and gently slide it into the bottom notch of the frame in place,
secure it by pressing the two clips on top side of the frame. Repeat with the other
glass panels. (See Fig.1 and Fig.2)
6. Install the bulb (not included). Check relamping label at socket area or packaging
for maximum wattage allowed.
Optional Installation: Disconnect Dusk-to-Dawn Photocell
IMPORTANT:
Compatible with dimmer when photocell is disconnected.
* Requires dimmable bulb and compatible dimmer switch.
Page 2 / 3
230210