Installation Guide

181212

The following parts are available for re-order if damaged or missing.

Turn on the power at fuse or circuit box.

Spare Parts List:

Mounting Hardware

6055MM (1SET)

Mounting Strap (A)

Mounting Screw (B)

Green Grounding

Screw (C)

Hex Nut (D)

Wire Connector (E)

Canopy (G)

Top Loop (H)

Collar (I)

Threaded Pipe (F)

Washer (J)

Loop Lock (K)

Chain (L)

A:8"

B:17"

Fig.1

Glass Panel

Clip

Metal

Frame

6. Make the bottom of the fixture upward, gently place four glass panels into the metal

frame, then press the clips to secure the glass panels. (Fig.1)

7.Pull out the source wires from the outlet box. Make wire connections using wire

connectors (E) as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from

the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire

from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the

mounting strap (A) with the green grounding screw (C), and then connect it to the

house grounding wire with the wire connector (E).

Carefully put the wires back into the outlet box.

8. Attach the canopy (G) to the mounting strap (A) by inserting the top loop (H), then secure it with the collar (I).

CAUTION: With silicone caulking compound, caulk completely around where back of canopy meets with the

ceiling surface to prevent water from seeping into the outlet box.

9. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.

Glass Panel

10071RG (4PCS)