Installation Sheet

ManualsBrandsVaxcel ManualsOutdoor Ceiling LightsVaxcel Lighting Cambridge 2 Light 12" Wide Outdoor Flush Mount Square Ceiling Fixture with Glass Panel Shades

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0472

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Green Grounding Screw (E)

Headless screw (D)

Mounting plate (A)

Lock Nut (F)

Ball Nut (G)

Mounting Screw (B)

Wire Connector (C)

Turn off the power at fuse or circuit box

Installation Steps

1. Thread two headless screws (D) through the mounting

plate (A), and then secure them with four lock nuts (F)

(two on each side of the mounting plate (A).) Adjust the

length of the headless screws (D) if necessary.

Note: Make sure the headless screws are lined up

horizontally to make the fixture level.

2. Attach the mounting plate (A) to the outlet box by

using two mounting screws (B).

3. Pull out the source wires from the outlet box.

Make wire connections using wire connectors (C)

as follows:

---Connect the hot wire (usually black insulation)

from the fixture to the black wire from the power

source.

---Connect the neutral wire (usually white insulation)

from the fixture to the white wire from the power

source.

---Attach the fixture grounding wire (usually green

insulation or bare wire) to the mounting plate (A)

with the green grounding screw (E), and then

connect it to the house grounding wire with the

wire connector (C).

Carefully put the wires back into the outlet box.

4. Attach the ceiling plate to the mounting plate (A) by

inserting headless screws (D) into the center holes

of the ceiling plate and screw two ball nuts (G) to

secure the ceiling plate.

181220

House Grounding Wire

Fixture Grounding Wire

Headless Screw (D)

Wire Connector (C)

Mounting Plate (A)

Green Grounding Screw (E)

Mounting Screw (B)

Lock Nut (F)

Outlet Box

Ceiling Plate

Socket

Ball Nut (G)

Set Screw

Metal Frame

Bulb Type A Max.60W

(not included)

Summary of content (2 pages)

PAGE 1
T0472 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO TO SHUT SHUT OFF OFF TOAVOID AVOID RISK RISK OF OF ELECTRICAL ELECTRICAL SHOCK, BE SURE TO POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Install two bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 6. Place the bottom glass into the metal frame, then secure it with eight clips which on the bottom of the metal frame. Place the side glass panels into the metal frame, then press the clips which on the top and bottom of the metal frme to secure the side glass panels. (See Fig. 1 ) Note: The patterned side of glass faces out . Fig.1 Side Glass Panel Bottom Glass Panel 7.