Installation Sheet

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
181121
Cross Bar (A)
Green Grounding
Screw (E)
Mounting Screw (B)
Wire Connector (C)
Lock Nut (F)
Ball Nut (G)
1. Attach two headles screws (D) to the cross bar (A),and
then secure it with four lock nuts (F). Adjust the length
of headless screws if necessary.
2. Attach the cross bar (A) to the outlet box using two
mounting screws (B).
3. Pull out the source wires from the outlet box.
Make wire connections using wire connectors (C) as follows:
---Connect the hot wire (usually black insulation) from the
fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation
or bare wire) to the cross bar (A) with the green grounding
screw (E), and then connect it to the house grounding wire
with a wire connector (C).
Carefully put the wires back into the outlet box.
4. Attach the fixture canopy to the cross bar (A) by inserting the
headless screws (D), and then secure it with two rubber pads
(H) and two ball nuts (G).
5. Install a bulb (not included). Check relamping label at socket
area or packaging for maximum allowed wattage.
6. Attach the glass onto the glass holder, secure it with four
replacement ball nuts.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0453
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Turn on the power at fuse or circuit box
Rubber Pad (H)
Headless Screw (D)
House Grounding Wire
Outlet Box
Cross Bar (A)
Mounting Screw (B)
Lock Nut (F)
Wire Connector (C)
Headless Screw (D)
Green Grounding Screw (E)
Turn off the power at fuse or circuit box
Installation Steps
Fixture Canopy
Ball Nut (G)
Rubber Pad (H)
Glass Holder
Replacement Ball Nut
Glass
Bulb Type A
Max. 60W
(not included)