Installation Sheet

Page 5 / 6
180720
Assembly Kit
5892MM (1 SET)
Spare Parts List:
Mounting Screw
X2
Wire Connector
X3
Mounting Strip
X1
Decorative Cover
X1
Fixture Mounting Screw
X1
The following parts are available for re-order if damaged or missing.
Problem
The light stays on continuously.
Possible Cause Solution
The motion sensor may be picking up
a heat source, such as an air vent,
dryer vent, or brightly painted,
heat-reflective surface.
Decrease the “SENSITIVITY” setting
or reposition the motion sensor.
Switch the motion sensor to auto.
See Using manual mode on page 4.
Do not use a dimmer or timer to
control the light fixture. Replace the
dimmer or timer with a standard
on/off wall switch.
Install the light fixture on a circuit
without motors, transformers, or
fluorescent bulbs.
The motion sensor is in manual mode.
The light fixture is wired through a
dimmer or timer.
The light fixture is on the same circuit
as a motor, transformer, or fluorescent
bulb.
The light flashes once then
stays off in manual mode.
The light flashes on and off.
The motion sensor is detecting light from
the lamp heads.
Reposition the lamp heads to keep
the
area below the motion sensor
relatively dark.
Heat or light from the lamp heads may
be turning the motion sensor on and off.
Heat is being reflected from other objects
and may be turning the motion sensor on
and off.
The motion sensor is in “TEST” mode
and warming up.
Reposition the lamp heads away
from the motion sensor.
Decrease the “SENSITIVITY” setting
or reposition the motion sensor.
While in “TEST” mode, the light only
stays on for 5 seconds. Set the
“TIME” switch to 5s to 3 minutes.
If unable to fix any of the above issues, please consult a certified electrician.