Installation Sheet

Page 3 / 6
180720
Function and Operation
1. TEST MODE (daytime and nighttime operation.)
● With the power on, the owl’s eyes turn to low-level brightness automatically and wall light is always on.
● The owl’s eyes and wall light turn to high-level brightness when motion is detected, and stay on as long as the
motion continues. Then the owl’s eyes switch back to low-level brightness about 5 seconds after motion is no longer
detected.
2. OFF MODE (nighttime operation only)
● To shift to the “OFF” mode, slide the switch to “OFF” position, and rotate Time knob to the desired time setting
(between 5 seconds and 3 minutes). At dusk, the owl’s eyes and wall light will be off , When the motion is
detected, both the owl’s eyes and wall light will be on at full brightness, When no longer movement, the owl’s
eyes and wall light at full brightness remain on for the predetermined time you set
(5s ~ 3min), after then the light turns off automatically.
● The light turns off automatically at dawn.
3. AUTO MODE (nighttime operation only)
● To shift to the “AUTO” mode, slide switch to “AUTO” position, and
rotate Time knob to the desired time setting (between 5 seconds
and 3 minutes). At dusk,the wall light is always on and the owl’s eyes
turn on at low brightness, When motion is detected, the owl’s eyes
turn to full brightness and stay on as long as motion continues.
When the motion is no longer detected,the owl’s eyes at full brightness
remain on for the predetermined time you set (5s ~ 3min), and then the
owl’s eyes switch back to low level automatically.
● The light turns off automatically at dawn.
4. PC MODE (nighttime operation only)
● The owl’s eyes and wall light turn on at full brightness at dusk
and remain “ON” until dawn.
5. Manual Override (nighttime operation only)
● To shift to the manual override mode, set the mode selector to
“OFF” “AUTO” mode. Turn the wall switch “OFF”, and turn it “ON”
twice within 3 seconds. The light will remain on all night long. To
shift back to “OFF” “AUTO” mode, turn the wall switch “OFF”, and
turn it “ON” twice within 3 seconds again.
● The light turns off automatically at dawn.
Note: To make sure the above functions operate properly,
always keep the wall switch in the “ON” position
(including the daytime).
“OFF” “AUTO”
MODE
Manual
Override
Turn wall switch OFF-ON
-OFF-ON in 0.5~3 Seconds
Turn wall switch OFF-ON
-OFF-ON in 0.5~3 Seconds
Fig. 5
TIME
3MIN
TEST
OFF PC
5S
AUTO
SENSITIVITY
Fig. 4
Shut-off Delay
Customization Options
● The shut-off delay is the length of time the light will stay at full brightness after motion is detected.
● You can set the shut-off delay by rotating the Time Delay knob so it points to the desired time setting(from
5 seconds to 3 minutes). To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay,
turn the knob counterclockwise.
Notes:
1. The sensitivity of the motion sensor will increase as the environmental temperature gets cooler. For best
performance, gently clean the lens with a soft cloth every 1 or 2 months to ensure maximum sensitivity.
2. For best performance, install fixture at least 6-8 feet above the ground. At such a height, the fixture will provide a
detection distance of up to 40 feet at 77 degrees Fahrenheit. (See Fig.6)
3. The sensor detects movement across a detection range of 120 degrees. (See Fig.7)
4. The sensor will be more sensitive to motion across its detection path than motion directly towards it. (See Fig.8)
5. To reduce possible nuisances, do not mount the fixture near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflective object or other nearby light source.
Manual Override Operation Diagram