Installation Guide

181009

5. Attach the shade to the socket, and then secure it with the socket ring.

6. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.

Turn on the power at fuse or circuit box.

A: 9"

B: 9"

C: 13.25"

The following parts are available for re-order if damaged or missing.

Spare Parts List:

1. Turn off the power at the fuse or circuit box before starting installation.

2. Loosen the wire connectors connected with the wires from photocell. (See Fig.1)

Note: Do not move the photocell to prevent water from seeping into the outlet box.

3. Take a white pigtail and black pigtail and make wire connections using wire connectors (F): (See Fig.2)

a. The black wire from the fixture to one end of the black pigtail.

b. The white wire from the fixture to one end of the white pigtail.

c. The other end of the black pigtail to the black wire from the power source.

d. The other end of the white pigtail to the white wire from the power source.

Put all wires back into the back plate of the fixture.

Operation the Unit Without Photocell

Photocell

White Wires From Photocell

Wire Connector

Wires From Fixture

Wires From

Main Power

Wire Connector (F)

White Pigtail

Pigtail

Red Wires From Photocell

Black Wires From Photocell

Fig.

Fig

Mounting Screw (B)

Rubber Pad (H)

Cross Bar (A)

Green Grounding

Screw (C)

Lock Nut (E)

Wire Connector (F)

Ball Nut (G)

Headless Screw (D)

Assembly Kit

5786MM (1 SET) for T0367

5787MM (1 SET) for T0370

5987MM (1 SET) for T0482

5988MM (1 SET) for T0486