Installation Guide

ManualsBrandsVAXCEL ManualsLightingOutland 1-Light Black Gold Farmhouse Outdoor Barn Dome Pendant

Outlet Box

House Grounding Wire

Wire Connector

Fixture Mounting Screw (E)

Mounting Strap (A)

Lock Nut (D)

Green Grounding Screw (B)

Mounting Screw (C)

Ball Nut (H)

Canopy

Rubber Pad (I)

Socket

Holder

Shade

Socket Ring

Bulb Type A Max.60W

(not included)

Fixture

171012

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

T0349

Hardware Package (included):

Mounting Screw (C)

Lock Nut (D)

Wire Connector

Ball Nut (H)

Mounting Strap (A)

Fixture Mounting

Screw (E)

Green Grounding

Screw (B)

Rubber Pad (I)

Strain Relief(G)

Strain Relief (G)

C(3")

D(3/8")

B(9")

FIG.1

1. Unscrew two ball nuts, remove mounting strap from canopy.

2. Thread the cord through the canopy and Strain Relief. Measure the

desired length of the cord (A) from the canopy to the shade and

Leave additional 9" cord (B) above the canopy(include the canopy).

Then cut off the unnecessary cord.(See Fig.1)

3. Adjust strain relief at 9" position from the top of the cord.

4. Mark the 3" cord (C) from the top of the cord (B). Use a knife to peel

off the insulation of the cord (C) carefully to show the 3 inside wires

out. (See Fig. 1)

Caution : Cutting too deep may cut off three inside wires and

destroy the insulation surface of the three inside wires.

5. Peel off the 3 wires from the top about 3/8" long(D) to expose the

copper for wiring.

6. Attach the mounting strap to outlet box by using two mounting screws.

7. Pull out the source wires from the outlet box. Make wire connections

using wire Connectors as follow:

---Connect the hot wire (usually black insulation) from the fixture to the

black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to

the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire)

to the mounting strap with the green grounding screw. Then connect it

to the house grounding wire with the wire Connector

Carefully put the wires back into the outlet box.

Turn off the power at fuse or circuit box.

Installation Steps

Summary of content (2 pages)

PAGE 1
T0349 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. Outlet Box 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
8. Pull the cord (A) down slightly until the strain relief touches the hex nut .Attach the canopy to the mounting strap by inserting two fixture mounting screws. then secure it with two ball nuts and two rubber pads. Note: Adjust the strain relief can decrease or increase the length of cord exposing outside. 9. Attach shade to fixture, then secure it with socket ring. 10. Install bulb(not included). See relamping label at socket area or packaging for maximum allowed wattage.