Installation Guide

Turn on the power at fuse or circuit box
161004
Green Grounding
Screw (E)
Nipple (D)
Mounting Screw (B)
Wire Nut (C)
Hex Nut (F)
Washer (G)
Mounting Strap (A)
Rubber Pad (L)
End Cap (M)
C
B
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Hardware
5600MM (1 SET)
A: 6-1/2”
B: 12”
C: 7-1/4”
1. Attach the nipple to the mounting strap, then secure it with a washer and hex nut.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using the wire
nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then connect it to
the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the fixture to the mounting strap by inserting the nipple, then secure it with the rubber pad and end
cap.
CAUTION: With silicone caulking compound, caulk completely around where the back plate meets
with the wall surface to prevent water from seeping into the outlet box.
5. Install a bulb (not included). See relamping label on socket area or packaging for maximum allowed wattage.
6. Turn on the power at the main fuse or circuit breaker box.