Installation Guide

141203
Turn on the power at fuse or circuit box.
Installation Steps
Turn off the power at fuse or circuit box.
1. Thread two headless screws through the mounting plate, then secure them with four lock nuts ( two on each side of the
mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally to ensure that the fixture will be level.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Hook the curved arm to the loop, and then attach the curved arm to the back plate by using the set screw.
4. Place the glass shade into the metal frame carefully, and then secure it by pressing the clips from the bottom side.
(See Fig.1)
5. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green grounding
screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
6. Attach the back plate to the mounting plate by inserting the headless screws, then secure it with two rubber pads and two
ball nuts.
CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall
surface to prevent water from seeping into the outlet box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Hardware
5165MM (1 SET)
Assembly Kit
5172AA (1 SET)
Green Grounding
Screw (C)
Ball Nut(G)
Mounting Screw (B)
Set Screw
Curved Arm
Wire Nut (D)
Lock Nut (F)
Headless Screw(E)
Rubber Pad (H)
Glass Shade
9645CK (1PCS)
Mounting Plate (A)
A: 6-1/8"
B: 13-1/8"
C: 7-1/4"