Installation Guide

141105

Turn on the power at fuse or circuit box.

The following parts are available for re-order if damaged or missing.

Spare Parts List:

5. Connect the other end of the chain to the canopy using the other loop lock.

6. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.

---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then connect it to the house

grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

7. Attach the canopy to the mounting strap by inserting the fixture mounting screws, and secure it with two bolt nuts.

8. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.

9. Screw the threaded pipe into the finial. Then attach the finial to metal frame with rubber pad (1), washer and hex nut.

10.Place the glass panels into the metal frame carefully, secure the buckles to fix the glass panels by using four pads and

four set screws. (See Fig.1)

11.Attach the metal frame to main fixture by inserting headless screws. Then secure it with rubber pads(2) and ball nuts.

Mounting Strap (A)

Mounting Screw (B)

Fixture Mounting

Screw (E)

Green Grounding

Screw (C)

Wire Nut (D)

Canopy Set(H)

Loop Lock (I)

Chain (J)

Bolt Nut (F)

Lock Nut(G)

Assembly Kit

5180MM (1 SET) for T0160

Hammered Glass

9648CH (1 SET) for T0160

A: 11"

B: 19-1/2"