Installation Guide

ManualsBrandsVaxcel ManualsOutdoor PendantsVaxcel Lighting Castile 1 Light Outdoor Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0160

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

141105

Turn off the power at fuse or circuit

Mounting Strap (A)

Mounting Screw (B)

Fixture Mounting

Screw (E)

Green Grounding

Screw (C)

Wire Nut (D)

Canopy Set(H)

Loop Lock (I)

Chain (J)

Bolt Nut (F)

Lock Nut(G)

1. Thread two fixture mounting screws through the mounting strap, then

secure them with two lock nuts. Adjust the length of the fixture

mounting screws if necessary.

2. Attach the mounting strap to the outlet box by using two mounting

screws.

3. Connect the chain:

- Determine length of chain needed to achieve desired fixture

height. (To remove excess chain section, use pliers to bend link

open.)

- Weave the fixture wires and fixture grounding wire through the

chain and canopy.

4. Connect one end of the chain to the loop using a loop lock.

Installation Steps

Loop

Main Fixture

Socket

Outlet Box

House Grounding Wire

Wire Nut (D)

Fixture Wire

Fixture Grounding Wire

Mounting Strap (A)

Green Grounding Screw (C)

Mounting Screw (B)

Canopy Set (H)

Bolt Nut (F)

Lock Nut (G)

Fixture Mounting Screw (E)

Loop Lock (I)

Chain (J)

Bulb Type A Max.100W

(not included)

Ball Nut

Rubber Pad(1)

Hex Nut

Washer

Set Screw

Pad

Buckle

Headless screw

Threaded pipe

Metal Frame

Glass Panel

Finial

Fig.1

Rubber pad(2)

Summary of content (2 pages)

PAGE 1
T0160 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Connect the other end of the chain to the canopy using the other loop lock. 6. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows: ---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source. ---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source. ---Attach the fixture grounding wire to the mounting strap with the green grounding screw.