Installation Guide

141029
--- Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar with the green grounding
screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate to the cross bar by inserting the screws, then secure it with two rubber pads and ball nuts.
CAUTION: With silicone caulking compound, caulk completely around where the back side of the fixture
meets with the wall surface to prevent water from seeping into the outlet box.
5. Secure the finial onto the fixture tightly.
6. Install bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.
1. Turn off the power at the main fuse or circuit breaker box before starting installation.
2. Loosen the wire nuts connected with the wires from photocell. (See Fig.1)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire nuts: (See Fig.2)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Photocell
White Wires From Photocell
Wire Nuts
Wires From Fixture
Wires From Fixture
Wires From
Main Power
Wire Nut
White Pigtail
Pigtail
Red Wires From Photocell
Black Wires From Photocell
Operation the Unit Without Photocell
Fig.1
Fig.2
Turn on the power at the main fuse or circuit breaker box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Glass Panel
9652C
Mounting Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Cross Bar (A)
Ball Nut (G)
Headless Screw (D)
Rubber Pad (H)
Assembly Kit
5189MM (1 SET) for T0130
5190MM (1 SET) for T0134