Installation Guide

T0103 --- Page 3 / 5
Adjustment Sensor Lower For Short Coverage
Adjustment Sensor Higher For Long Coverage
Fig. 5
1. Gently grasp the light heads and tilt them up or down, left or right to
adjust the light coverage area. Keep the light heads at least 1˝ (25mm)
away from the sensor.(See Fig. 5)
2. Keep the light heads 30˚ below horizontal to avoid water damage and
electrical shock.
Fig. 3
Fig. 4
Adjusting the Light Head:
Function and Operation
Note: When power is first applied, the light will turn on to 100% brightness. The sensor will take 30 seconds
to warm up.
1. AUTO MODE (nighttime operation only)
After expiration of the warm-up period, the light will enter a
5-minute TEST mode (day and night operation) and be on
at low-level brightness (0-50%). The light will turn to high-
level brightness (100%) when motion is detected. It will then
revert to low-level brightness about 5 seconds after motion
is no longer detected.
After expiration of the TEST mode, the light will automatically
enter AUTO mode and be on at low-level brightness (0-50%).
The light will turn to high-level brightness (100%) when
motion is detected. When the motion stops, the light will then
revert to low-level brightness after the shut-off delay time you
set ( 5 ~ 180 seconds).
The light will turn off automatically at dawn.
Note: You can adjust the low level brightness (0~50%) by using
the low level brightness knob. (See Fig. 7)
2. 3 HOURS (3H) MODE (nighttime operation only)
The light will turn to high-level brightness (100%) at dusk, and
will stay "ON" for 3 hours. The light will then turn to low-level
brightness. The light will turn to high-level brightness (100%)
when motion is detected, and will stay on as long as motion
continues. When motion is no longer detected, the lights will
remain on for the predetermined shut-off delay
time you set (5~180 seconds), and then turn to the predetermined low-level brightness automatically.
The light will turn off automatically at dawn.
Note: You can adjust the low level brightness (0~50%) by using the low level brightness knob. (See Fig. 7)
Fig. 6
Fig. 7
Mode
Sensitivity
Delay Time Low Level Brightness
Sensitivity of Motion Sensor
You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right side
of the bottom surface of the sensor. (See Fig. 6)
Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to achieve desired performance.
Approximate range for each setting: 20 ft. (L), 45 ft. (M), 70 ft. (H).
140919