Installation Guide

1. Attach the two fixture mounting screws to the holes on
the cross bar, then secure them with two lock nuts.
Adjust the length of the fixture mounting screws if
necessary.
2. Attach the cross bar to the outlet box by using two
mounting screws.
3. Pull out the outlet wires and the house grounding wire
from the outlet box. Make wire connections using the
wire nuts:
---The black wire from the fixture to the black wire from
the power source.
---The white wire from the fixture to the white wire from
the power source.
---Attach the fixture grounding wire to the cross bar with
the green grounding screw. Then connect it to the
house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the ceiling by aligning fixture
mounting screws on cross bar with holes on ceiling pan.
Slide fixture mounting screws through holes, secure
it with two ball nuts.
5. Install bulbs (not included). See relamping label at
socket area or packaging for maximum allowed wattage.
6. Attach the metal ring onto the metal frame by aligning
holes, secure it by using the set screws.
7. Take glass shade and gently slide it into the metal frame
in place.
8. Attach the metal frame to the ceiling pan by aligning the
holes on metal frame with the holes on ceiling pan,
secure them with two ball nut assemblies.
9. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0097
Outlet Box
House Grounding Wire
Wire Nut(E)
Ceiling Pan
Glass Shade(H)
Metal Ring
Set Screw
Cross Bar (A)
Green Grounding Screw(C)
Mounting Screw(B)
Bulb Type A Max.60W
(not included)
Lock Nut (G)
Parts:
Parts Number (5015MM)
Parts Number (9583CS)
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Nut (E)
Glass Shade (H)
Cross Bar (A)
Ball Nut (F)
140321
Fixture Mounting Screw (D)
Fixture Mounting Screw (D)
Lock Nut (G)
Ball Nut (F)
Metal Frame
Ball Nut Assembly
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.