Installation Guide

140324
A: 8"
B: 13-1/2"
A
B
4. Secure the top loop to nipple-1.
5. Choose the length of the chain you need, then weave the fixture wire and the fixture grounding
wire through the chain. Then connect one end of the chain with the loop by using the loop lock.
6. Thread the fixture wire and fixture grounding wire through the collar, canopy, top loop, nipple
and mounting strap.
7. Connect the other end of the chain with the top loop by using the loop lock.
8. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
by using the wire nuts:
---The smooth wire (marked) from the fixture to the black wire from the power source.
---The ridged wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
9. Attach the canopy to the mounting strap by inserting the top loop, then secure it with the collar.
Note: With silicone caulking compound, caulk completely around where back of
canopy meets with the ceiling surface to prevent water from seeping into the outlet box.
10. Install a bulb (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
11. Attach the inner glass shade to the glass holder and turn it clockwise until it locks in place.
Note: Do not over tighten.
12. Attach the dome to the metal frame, then secure it with two ball nut assemblies.
13. Turn on the power at the main fuse or circuit breaker box.