Installation Guide

ManualsBrandsVaxcel ManualsOutdoor PendantsVaxcel Lighting Cadiz 1 Light Outdoor Lantern Small Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0089

Bulb Type A Max.60W

(not included)

Interior Glass Shade (M)

Dome

Set Screw

Nipple-1

Parts:

140324

Metal Frame

Loop

Parts Number (5009MM)

Mounting Strap (A)

Mounting Screw (B)

Green Grounding

Screw (C)

Wire Nut (D)

Canopy (I)

Loop Lock (K)

Chain (L)

Outlet Box

House Grounding Wire

Wire Nut (D)

Fixture Wire

Fixture Grounding Wire

Mounting Strap (A)

Green Grounding Screw (C)

Mounting Screw (B)

Nipple(G)

Canopy (I)

Top Loop (H)

Hex Nut (E)

Washer (F)

Collar (J)

Loop Lock (K)

Chain (L)

Hex Nut (E)

Washer (F)

Nipple(G)

Top Loop (H)

Collar (J)

1. Attach nipple to the mounting strap, then secure it

with a washer and hex nut.

2. Attach the mounting strap to the outlet box by using

two mounting screws.

3. Place the outer glass shade into the metal frame

carefully, and then secure it by pressing the clips from

the top sides. (See Fig.1)

Note: Slide the outer glass shade downward into

the notch inside of the metal frame.

Exterior Glass Shade (N)

Parts Number (9573CE)

Parts Number (9574AM)

Exterior Glass Shade (N)

Interior Glass Shade (M)

Fig. 1

Metal Frame

Clip

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0089 WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Secure the top loop to nipple-1. 5. Choose the length of the chain you need, then weave the fixture wire and the fixture grounding wire through the chain. Then connect one end of the chain with the loop by using the loop lock. 6. Thread the fixture wire and fixture grounding wire through the collar, canopy, top loop, nipple and mounting strap. 7. Connect the other end of the chain with the top loop by using the loop lock. 8. Pull out the outlet wires and the house grounding wire from the outlet box.