Installation Guide

ManualsBrandsVaxcel ManualsOutdoor Wall SconcesVaxcel Lighting Nottingham 3 Light Outdoor Wall Sconce - 10.5 Inches Wide

140324

1. Take a side glass panel and gently place the side

glass panel into the metal frame in place, then

pressing the clips of the metal frame to secure the

side glass panel. (See Fig. 1)

2. Repeat this process to complete all glass panel

installation of side glass panels and front glass

panel.

3. Take an upper glass panel and gently place the

upper glass panel into the dome in place, then

pressing the clips of the dome to secure the upper

glass panel. (See Fig. 2) Repeat with other upper

glass panels.

4. Attach the dome to the metal frames, then secure it

with the ball nut assemblies.

5. Thread two headless screws to the cross bar, and

secure them with four lock nuts (two on each side

of the cross bar). Adjust the length of the headless

screws if necessary.

6. Attach the cross bar to the outlet box by using two

mounting screws.

7. Pull out the outlet wires and the house grounding

wire from the outlet box. Make wire connections

by using the wire nuts:

---Connect the black (hot) wire from the fixture to the

black (hot) wire from the power source.

---Connect the white (neutral) wire from the fixture to

the white (neutral) wire from the power source.

---Attach the fixture grounding wire to the cross bar

with the green grounding screw. Then connect

it to the house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

8. Attach the back plate to the cross bar by inserting the

headless screws, then secure it with two rubber pads

and two ball nuts.

Note: With silicone caulking compound, caulk completely around where the back plate

meets with the wall surface to prevent water from seeping into the outlet box.

9. Open the door of the fixture by pushing up the latch, attach the candle tube onto the socket.

10. Install bulbs (not included). See relamping label at socket area or packaging for maximum

allowed wattage.

Close the door of the fixture by pulling down the latch.

11. Turn on the power at the main fuse or circuit breaker box.

A: 9"

B: 20"

C:10-1/4"

Fig. 1

Clip

Fig. 2

Glass Panel

Clip

Glass Panel

Clip