Installation Guide

B
A
191205
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
6160MM (1 SET)
Glass Shade
X1
10121CS
A: 16-1/8"
B: 11-3/4"
9. Pull out the source wires from the outlet box. Make wire connections using wire connectors (F) as follows:
a. Connect the hot wire marked "L" from the fixture to the black wire from the power source.
b. Connect the neutral wire marked "N" from the fixture to the white wire from the power source.
c. Connect the copper wire or green wire marked " " from the fixture to the mounting strap (A) by securing it with the
green ground screw. The green ground wire marked " " from the fixture to the green ground wire from power source.
Carefully put wires back into the outlet box.
10. Pull the cord (a) down slightly until the strain relief (G) touches the hex nut. Attach two fixture mounting screws (E)
to the mounting strap (A), then secure it with two lock nuts (D). Adjust the length of the fixture mounting screws (E)
if necessary, then secure it with two ball nuts (H).
11. Fastening cord by screwing plastic headless screw, using flat head screwdriver (I). Move the rubber ring of the fixture
wire and guy wire to the proper position to achieve beautiful.
12. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box.
Mounting Screw (B)
Wire Connector (F)
Strain Relief (G)
Mounting Strap (A)
Fixture Mounting Screw (E)
Green Ground Screw (C)
Lock Nut (D)
Ball Nut (H)
Flat Head Screwdriver (I)