Installation Sheet

ManualsBrandsVaxcel ManualsChandeliersVaxcel Lighting Hailey 4 Light 32" Wide Taper Candle Chandelier

1. Thread two fixture mounting screws to

the mounting plate, and secure them

with two lock nuts.

2. Place the mounting plate to the outlet box and

mark the target on the wall from the set hole for

drilling two holes. Remove the mounting plate

from the outlet box. Thread the anchors into the holes,

then attach the mounting plate to the outlet box by

using two mounting screws. Secure the dry wall

screws through the set holes into the anchors.

3. Rod Connections:

a. Thread the fixture wire from the

fixture through the lower rod, and

then secure the lower rod onto

fixture using the threaded pipe.

b. Thread the fixture wire through the

middle rod, and then secure the

middle rod onto the lower rod using

the threaded pipe.

c. Thread the fixture wire through the

upper rod, and then secure the upper

rod onto the middle rod using the

threaded pipe.

Note: Length adjustable from 14" to 82".

Use fewer rods if shorter length is desired.

181108

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THIS INSTRUCTION.

P0281

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Mounting Plate (A)

Mounting Screw (B)

Ball Nut (G)

Anchor (I)

Dry Wall Screw (H)

Green Grounding

Screw (C)

Fixture Mounting Screw (D) Lock Nut (E)

Wire Connector (F)

Outlet Box

Housing Grounding Wire

Wire Connector (F)

Fixture Wire

Fixture Grounding Wire

Mounting Plate (A)

Green Grounding Screw (C)

Fixture Mounting Screw (D)

Lock Nut (E)

Set Hole

Canopy

Dry Wall Screw (H)

Ball Nut (G)

Mounting Screw (B)

Anchor (I)

Washer (J)

Hex Nut (K)

Loop Lock (L)

Chain (M)

Loop

Loop Lock

Upper Rod

Threaded Pipe

Middle Rod

Lower Rod

Hex Nut (K)

Washer (J)

Loop Lock (L)

Chain (M)

Bulb Type B Max.60W

(not included)

Summary of content (2 pages)

PAGE 1
P0281 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THIS INSTRUCTION.
PAGE 2
4. Connect one end of the chain with the loop by using a loop lock. 5. Connect the other end of the chain with the top loop by using another loop lock. 6. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows: ---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source. ---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.