Installation Sheet

161120

Turn on the power at fuse or circuit box

5. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the black wire from the fixture to the black wire from the power source.

---Connect the white wire from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the mounting plate with the green grounding screw, and then connect it to the

house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

6. Attach the fixture canopy to the mounting plate by inserting the fixture mounting screws, and then secure it with two

ball nuts.

7. Push the pc diffuser into the shade

with oblique angel. (Fig.1)

8. Insert the sensor head into the hole of pc diffuser while the half of pc

diffuser reaches the shade, then tighten it with lock ring .Push the half

pc diffuser into the shade and place it in place (Fig.2).

9.Angled mounting recommended for a vaulted or angled

ceiling. (See Fig. 3)

Function and Operation

TURNING LIGHTS ON, OFF

Wave hand under 4 inches of

sensor once to turn light on or off.

LOCK / UNLOCK LIGHT

Wave hand under 4 inches of sensor

within 0. 5 seconds twice to lock or

unlock sensor.

NOTE: Dimming ranges from 100%

to 5% brightness.

DIMMING LIGHTS

Hold hand under 4 inches of sensor

to adjust brightness.

ON-OFF

LOCK-UNLOCK

DIMMING

PC Diffuser

Shade

Fig.1

Lock Ring

Sensor Head

PC Diffuser

Fig.2

Fig. 3

Outlet Box

Support Brace

Canopy

Coupling Kit