Installation Guide

ManualsBrandsVaxcel ManualsChandeliersVaxcel Lighting Descartes II 6 Light Single Tier Chandelier with Glass Shades - 38.5 Inches Wide

Canopy

Canopy Loop

Bolt Nut

Loop Lock

Fixture Wire

Upper Fixture

Fixture Grounding Wire

Glass Shade

Glass Holder

Socket Ring

Chain

Loop

1. Thread two headless screws through the mounting

plate,then secure them with four lock nuts (Two on

each side of the mounting plate). Adjust the length

of the headless screws if necessary.

2. Attach the mounting plate to the outlet box by using

two mounting screws.

3. Carefully secure the upper fixture to the main fixture

by screwing the nipples into the couplings and secure

it with the hex nuts.

4. Secure the loops to the nipples by using the plastic

pads and the plugs.

5. Choose the length of the chains you need. Connect

one end of the chains to the loops by using the loop

locks, then weave the fixture wire and the fixture

grounding wire through one of the chains. Then

connect the other end of the chains with the canopy

loop by using the loop locks.

6. Thread the fixture wire and fixture grounding wire

through one of the canopy loop and the canopy.

7. Pull out the outlet wires and the house grounding wire

from the outlet box. Make wire connections using the

wire nuts:

---The smooth wire (marked) from the fixture to the

black wire from the power source.

---The ridged wire (unmarked) from the fixture to the

white wire from the power source.

---Attach the fixture grounding wire to the mounting

plate with the green grounding screw. Then

connect it to the house grounding wire with a

wire nut.

Carefully put the wires back into the outlet box.

8. Attach the canopy to the mounting plate by inserting

the headless screws, then secure it with the bolt

nuts.

9. Attach the glass shades to the glass holders, and

secure them with the socket rings.

10. Install bulbs (not included). See relamping label at

socket area or packaging for maximum allowed

wattage.

11. Turn on the power at the main fuse or circuit breaker box.

Lock Nut

Outlet Box

Wire Nut

Headless Screw

Mounting Plate

Green Grounding Screw

House Grounding Wire

Mounting Screw

Fixture Wire

Hex Nut

Plastic Pad

Plug

Coupling

Main Fixture

Nipple

Bulb Type A Max.100W

(not included)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

P0114

141114