Installation Guide

Fixture
Mounting Screw
Screw
Fixture Wire
Lock Nut
Cross Bar
Ground Wire
Ground Screw
Wire Nut
Wall Box
Ball Nut
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT
OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
OW24381
Installation Steps
1.Thread the 2 screws through the cross bar, and then secure with 2 lock nuts.
(You can adjust the length of the screws if necessary.)
2.Attach the cross bar to the wall box by using 2 mounting screws.
3. Make wire connections with wire nuts:
---The black wire from fixture to the black wire from power source.
---The white wire from fixture to the white wire from power source.
---Attach the ground wire and the house ground wire to the cross bar
with a green ground screw.
Carefully tuck wires back into the wall box.
4. Attach the fixture to the cross bar by inserting the 2 screws, and then
secure with the ball nuts.
5. Install a bulb. (Please do not exceed the maximum capacity which is
recommended on the package.)
6. Unscrew the 2 ball nuts from the 2 set screws.
7. Insert the set screws into the both ends of the stand, and then secure with
the 2 ball nuts.
P.S: Make sure the ball nuts of the stand is securely tightened.
8. Attach the dome, the bell set onto the top stem, and then secure with the
top finial.
9. Attach the down finial to the fixture by using the down stem.
9.Turn on the power at fuse or circuit box.
Set Screw
Ball nut
Dome
Top Stem
Bell set
Top Finial
Down Finial
Down Stem
Stand