Use and Care Manual

ManualsBrandsVAXCEL ManualsChandeliersAvers 4-Light LED Compatible Gold Brass Mid-Century Modern Chandelier White Globe Glass

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Read and save this instructions.

H0295

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Installation Steps

. Unscrew the bolt nuts (D), take out the mounting plate

unit (A) and then attach to the outlet box by using two

mounting screws (B).

2. Rod Connections:

a. Thread the fixture wire through the lower rod,

then secure the lower rod onto fixture using the

threaded pipe.

b. Thread the fixture wire through the middle rod

and then secure the middle rod onto the lower

rod using the threaded pipe.

c. Thread the fixture wire through the upper rod,

then secure the upper rod onto the middle rod

using the threaded pipe.

Note: Length adjustable from 27-1/4" to 69-1/4".

Use fewer rods if shorter length is desired.

3. Thread the fixture wire through the canopy kit, then

secure the rod assembly to the set threaded pipe of

the canopy kit.

4. Pull out the source wires from the outlet box.

Make wire connections using wire connectors (C) as follows:

---Connect the smooth-coated wire (marked) from the fixture to

the black wire from the power source.

---Connect the ribbed-coated wire (unmarked) from the fixture

to the white wire from the power source.

---Attach the fixture ground wire (bare wire) to the mounting plate

unit (A) with the green ground screw, then connect it to the

house ground wire with the wire connector (C).

Carefully put the wires back into the outlet box.

5. Attach the canopy kit to the mounting strap unit (A) by inserting the fixture mounting screws,

then secure it with two bolt nuts (D).

6. Separate and adjust the arms to desired position.

Hardware Package (included):

Wire Connector (C)

Mounting Screw (B)

Mounting plate Unit (A)

Bolt Nut (D)

House Ground Wire

Fixture Ground Wire

Fixture Mounting Screw

Wire Connector (C)

Bolt Nut (D)

Mounting Plate Unit (A)

Green Ground Screw

Mounting Screw (B)

Fixture Wire

Outlet Box

Canopy Kit

Page 1 / 2

Max. 60W Medium Base

A15 Bulb (not included)

Set Threaded Pipe

Socket

Arm

Fixture

Glass Shade

Upper Rod

Middle Rod

Threaded Pipe

Lower Rod

Threaded Pipe

231120

Summary of content (2 pages)

PAGE 1
H0295 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO TO SHUT SHUT OFF OFF TOAVOID AVOID RISK RISK OF OF ELECTRICAL ELECTRICAL SHOCK, BE SURE TO POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Read and save this instructions.
PAGE 2
Fig. 1 7. Install 4 x 60W Max. medium base A15 bulbs (not included). See relamping label at socket area or packaging for maximum wattage allowed. Support Brace 8. Attach the glass shades to the glass holders by aligning slots, and then turn glass shades clockwise until they are locked in place. Outlet Box Canopy Kit 9. Angled mounting recommended for a vaulted or angled ceiling. Coupling Kit Turn on the power at fuse or circuit box The following parts are available for reorder if damaged or missing.