Installation Sheet

ManualsBrandsVaxcel ManualsChandeliersVaxcel Lighting Astor 6 Light 32" Wide Chandelier with Glass Shades

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

H0229

WARNING:

AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

181126

Turn off the power at fuse or circuit box.

Installation Steps

1. Thread two fixture mounting screws to the mounting plate, and

secure them with two lock nuts.

2. Fix the mounting plate to the wall.

a) For wooden material:

Attach the mounting plate to the outlet box by using two

mounting screws, and then secure the dry wall screws

through the set holes to the wall.

b) For cement material:

Place the mounting plate to the outlet box

and mark the target on the wall from the set

hole for drilling four holes. Remove the

mounting plate from the outlet box. Thread

the anchors into the holes, then attach the

mounting plate to the outlet box by using two

mounting screws. Secure the dry wall screws

through the set holes into the anchors.

3. Two sets of the rods, 3"L(x2), 6"L(x2) and 12"L(x8),

are attached in the hardware package, choose the

desired installation height you need. Then thread the

fixture wire through the rods and threaded pipes as

showed the right picture.Then secure the rod onto

decoration of main fixture. Length adjustable from

16-1/2" to 64-1/2". Use fewer rods if shorter length

is desired. Screw all rods together until securely by

using the threaded pipes, and then lock to the set

nipple of the swivel.

Hardware Package (included):

Fixture Mounting screw (E)

Mounting Screw (B) Green Grounding Screw (C)

Wire Connector (D)

Lock Nut (F)

Anchor (A)

Dry Wall Screw (G)

Ball Nut (H)

Outlet Box

Anchor (A)

Fixture Mounting Screw (E)

Green Grounding Screw (C)

Mounting Screw (B)

Dry Wall Screw (G)

Lock Nut (F)

Wire Connector (D)

Hex Nut

Metal Pad

Canopy

Swivel

Set Nipple

Upper Rod

Ball Nut (H)

Threaded Pipe

Middle Rod

Lower Rod

Decoration

Glass Shade

Main Fixture

Glass Holder

Glass

Holder

Bulb Type GU10 Max.7W

(included)

Bulb Type T Max

60W (not included)

3-Way Switch

Summary of content (2 pages)

PAGE 1
H0229 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Repeat with the other threaded pipes and rods. 5. Place the metal pad and canopy onto the swivels, secure them with two washers and two hex nuts. 6. Pull out the source wires from the outlex box. Make wire connections using wire connectors as follows: ---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.