Installation Sheet

ManualsBrandsVaxcel ManualsChandeliersVaxcel Lighting Huntley 3 Light 20" Wide Chandelier with Glass Shades

181009

H0213 / H0214 / H0215 / H0216

Mounting Strap (A)

Mounting Screw (B)

Fixture Mounting

Screw (D)

1. Thread two fixture mounting screw through the mounting strap, and

then secure with two lock nuts. Adjust the length of the fixture

mounting screws if necessary.

2. Attach the mounting strap to the outlet box by using mounting screw.

3. Rod Connections

a. Thread the fixture wire from the fixture through the lower rod, and

then secure the lower rod onto fixture usint the threaded pipe.

b. Thread the fixture wire through the middle rod, and then secure

the middle rod, and then secure the middle rod onto the lower

rod using the threaded pipe.

c. Thread the fixture wire through the upper rod,and then secure the

upper rod onto the middle rod using the threaded pipe.

d. Thread the fixture wire through the hook and fixture canopy, and then

secure the hook onto the upper rod using the threaded pipe.

Note: Length adjustable from 32-1/4" to 86-1/4" . Use

fewer rods if shorter length is desired.

4. Hang the hook to the loop of the fixture canopy.

5. Pull out the outlet wires and house grounding wire

from the outlet box. Make wire connections using

the wire connectors:

---The smooth wire (marked) from the fixture to the

black wire from the power source.

---The ridged wire (unmarked) from the fixture to the

white wire from the power source.

---Attach the fixture grounding wire to the mounting

strap with the green grounding screw. Then connect

it to the house grounding wire with a wire connector.

Carefully put wires back into the outlet box.

6. Attach the fixture canopy to the mounting strap by inserting

the fixture mounting screw, and then secure it with two ball nuts.

Green grounding

Screw (E)

Outlet Box

House Grounding Wire

Wire Connector (C)

Fixture Mounting Screw (D)

Mounting Strap (A)

Lock Nut (F)

Mounting Screw (B)

Green Grounding Screw (E)

Fixture Canopy

Ball Nut (G)

Threaded Pipe

Upper Rod

Threaded Pipe

Middle Rod

Threaded Pipe

Glass Shade

Glass Bracket

Set Screw (H)

Socket

Type A Max.60W

( not included )

Lower Rod

Installation Steps

Lock Nut (F)

Ball Nut (G)

Set Screw (H)

Wire Connector (C)

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Summary of content (2 pages)

PAGE 1
H0213 / H0214 / H0215 / H0216 NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
7. Install 3x60W Max medium base bulb ( not included) to the socket. Check relamping label at socket area or packaging for maximum allowed wattage. Support Brace 8. Attach the glass shade to the glass bracket by threading set screws onto glass notches. ( Do not over tighten.) Outlet Box 9. Angled mounting recommended for a vaulted or angled ceiling. ( See Fig.1) Canopy Turn on the power at fuse or circuit box. The following parts are available for re-order if damaged or missing.