Installation Guide

H0116 / H0117
Socket Ring
Glass Shade
Mounting Screw
Nipple(-a)
Mounting Strap
Green Grounding Screw
Hex Nut
Wire Nut
Washer
Outlet Box
Canopy
Loop
House Grounding Wire
Nipple(-b)
Chain
Fixture Grounding Wire
Collar
Top Loop
Loop Lock
Loop Lock
Fixture Wire
Glass Holder
Upper Fixture
1.Attach the nipple(-a) to the mounting strap, then secure it with
a washer and a hex nut.
2.Attach the mounting strap to the outlet box by using two mounting
screws.
3.Secure the top loop to nipple(-a).
4.Carefully secure the upper fixture to the main fixture by screwing
the nipple(-b) into the coupling(-a) and secure it with a hex nut.
5.Secure the loop and the rubber pad to nipple(-b) by using the plug.
6.Screw nipple(-c) into the coupling(-b),then attach the cap to the
coupling(-b) by inserting nipple(-c) and secure it with the finial.
7.Choose the length of the chain you need, then weave the fixture
wire and the fixture grounding wire through the chain, collar and
canopy.
8.Connect one end of the chain with the loop by using a loop lock.
9.Connect the other end of the chain with the top loop by using
another loop lock.
10. Thread the fixture wire and fixture grounding wire through the top
loop, nipple(-a) and mounting strap.
11. Pull out the outlet wires and the house grounding wire from the
outlet box. Make wire connections using the wire nuts:
---The smooth wire (marked) from the fixture to the black wire
from the power source.
---The ridged wire (unmarked) from the fixture to the white wire
from the power source.
---Attach the fixture grounding wire to the mounting strap with
the green grounding screw. Then connect it to the house
grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
12. Attach the canopy to the mounting strap by inserting
the top loop, then secure it with the collar.
13. Attach the glass shades to the glass holders, then
secure them with the socket rings.
14. Install bulbs (not included). See relamping label at
socket area or packaging for maximum allowed
wattage.
15. Turn on the power at the main fuse or circuit
breaker box.
Coupling(-a)
Hex Nut
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1.Before installing, consult local electrical codes for wiring and grounding requirements.
2.READ AND SAVE THESE INSTRUCTIONS.
Nipple(-c)
Cap
Finial
Plug
Coupling(-b)
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Main Fixture
Nipple(-b)
Bulb Type A Max. 100W
(not included)
Rubber Pad
141114