Owner's Manual

1. Attach the nipple to the mounting strap, then secure it with a
washer and hex nut.
2. Attach the mounting strap to the outlet box by using two
mounting screws.
3. Secure the top loop to the set nipple.
4. Attach the loop to the set nipple of the fixture.
5. Adjust the arms of the fixture according to the drawing of the
package. Then fix them to the metal ring by using the set
screws.
Important:
a.The arms should be positioned with equal distance
between them.
b. The arms should be fixed securely.
6. Choose the length of the chain you need, then weave
the fixture wire and the fixture grounding wire through
the chain, collar and canopy.
7. Connect one end of the chain with the loop by using a
loop lock.
8. Connect the other end of the chain with the top loop by
using another loop lock.
9. Thread the fixture wire and fixture grounding wire through
the top loop, nipple and mounting strap.
10. Pull out the outlet wires and house grounding wire from
the outlet box. Make wire connections using the wire nuts:
---The smooth wire (marked) from the fixture to the black
wire from the power source.
---The ridged wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
11. Attach the canopy to the mounting strap by inserting the top loop, then secure it with the collar.
12. Attach the glass shades to the glass holders, then secure them with the spacers and socket rings.
13. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
14. Turn on the power at the main fuse or circuit breaker box.
Loop
Contents of Spare Parts:
Outlet Box
House Grounding Wire
Wire Nut
Fixture Wire
Fixture Grounding Wire
Mounting Strap
Green Grounding Screw
Mounting Screw
Nipple
Canopy
Top Loop
Hex Nut
Washer
Collar
Loop Lock
Loop Lock
Chain
Fixture
Glass Holder
Socket Ring
Glass Shade
Bulb Type A Max.100W
(not included)
Spacer
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
H0012 / H0023
120312
Glass Shade
(3 PCS)
(9326FO For H0012)
(9327CH For H0023)
Set Nipple
Metal Ring
Set Screw
Assembly Kit
(1 SET)
(4493MM For H0012)
(4494MM For H0023)
Socket Ring
(3 SET)
(4483KK)