Installation Sheet

PAGE: 2 / 4
Secure the canopy to hanger bracket
with screws.
Thread the blade screws through the
holes in the blade holder and the holes
in the blade, and into the decorative
plates. Tighten all screws securely.
Repeat with other blade.
Note: Place the blade holders onto the
blades properly according to the marks
respectively labeled on the blade holders
and blades.
Blue
Green (Ground)
Fig.8
Secure blade holders to the motor
with motor screws and washers.
Fig.10
Screw
Canopy
Blade Screw
Blade Holder
Blade
Decorative Plate
Fig.11
Fig.12
Motor Screw
Blade Holder
Fig.13
Switch Box Screw
Switch Box Cover
Make wire connections:
1). The white motor wire to the white wire from the outlet box with a wire nut.
2). The black motor wire and blue wire to the black wire from the outlet box with
a wire nut.
3). The ground wire from the outlet box to the ground wire from the motor
with a wire nut.
*** After making the wire connections, the wires should be spread apart with the
grounded wires on one side of the outlet box and the ungrounded wires on the
other side of the outlet box.
*** After the connections have been made, the wires should be turned upward and
pushed carefully up into the outlet box.
Assembly without fan light
Make sure the wires of the fan light in
the switch box are capped with wire
nuts. Secure the switch box cover with
the switch box screws.
Note: To install the fan light, skip this
step and proceed to Fig.14.
Fan Light Installation:
Fig.9
Attach the loop at the end of the safety cable to the ceiling surface,
then secure it with a flat washer and dry wall screw. Make sure the
flat washer and dry wall screw are covered by the fan canopy.
Flat Washer
Safety Cable
Dry Wall Screw
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in current limiting device to conserve
energy. The fan light will not operate if the combined wattage of the installed bulbs exceeds 190
Watts. If the fan light shuts off shortly after being switched on, it may be due to excessive current
demand. Turn off power to the fan and replace the light bulbs with lower wattage bulbs.Turn on
power to the fan, using the pull chain, wall switch, or remote control (whichever is installed on the
particular fan).
090406
F A N C OF A N C O