Use and Care Manual

Fig.5.Fig.5
Connect the ground wires
(Green or bare copper) coming
from outlet box, mounting
bracket and mounting bar with
a wire connector.
For a single switch
Follow these steps:
Connect the white (neutral)
wire from motor to the white
(neutral) wire from the outlet
box with a wire connector.
Connect the black (hot) wire
(This is for fan control) and blue
wire (This is for light control) from
motor to the black (hot) wire from
outlet box with a wire connector.
After making the wire connections, the wires should
be spread apart. The white (neutral) conductor and
green (grounding) conductor on one side and the
black (hot) conductor and blue (light) conductor on
the other side of the outlet box.
The wire connection points should be turned upward
and pushed carefully up into outlet box.
Connect the ground wires
(Green or bare copper)
coming from outlet box,
mounting bracket and
mounting bar with a wire
connector.
For dual switch
Follow these steps:
Fig.5.Fig.6
Connect the black (hot) wire
from motor (This is for fan
control) to the black (hot)
wire from outlet box with a
wire connector.
Connect the blue wire (This is
for fan light control) from motor
to the blue wire from outlet box
with a wire connector.
Connect the white (neutral)
wire from motor to the white
(neutral) wire from the outlet
box with a wire connector.
After making the wire connections, the wires should
be spread apart. The white (neutral) conductor and
green (grounding) conductor on one side and the
black (hot) conductor and blue (light) conductor on
the other side of the outlet box.
The wire connection points should be turned upward
and pushed carefully up into outlet box.
PAGE: 5 / 9
231101
Hang the safety cable into the safety cable
hook, tighten the safety cable to the safety
cable hook by using the zip-tie.
Fig.5.Fig.7
Safety Cable Hook
Safety Cable
Zip-tie