Instructions / Assembly

PAGE: 8 / 9

Transmitter

Wall Bracket

Screw

Note: Remote controller can not be worked along with solid-state speed control at the same time.

Turn OFF the electric circuit at the main fuse or circuit breaker box. (See Fig.18)

Turn ON the electric circuit at the main fuse or circuit breaker box.

Fig.19

Receiver

Canopy

Hanger Bracket

Unscrew the canopy. Remove the wire connectors from the fan to ceiling

wire connection. The receiver should be removed from the hanger bracket.

(See Fig.19)

Install the battery (9V, included) to the transmitter.

* Press "HI" button to turn on the fan at high speed.

* Press "MED" button to turn the fan in medium speed.

* Press "LOW" button to turn the fan in low speed.

* Press "FAN OFF" button to turn off the fan.

* Press "REVERSE" button to set direction of fan rotation.

The fan will shift to high speed regardless of which fan speed was previously selected.

Then, the speed will slow down until the fan is turned off and it will restart by spinning in

the reverse direction and resume the previously selected speed setting.

* Press "LIGHT ON/OFF" button to turn on or turn off the light.

* Press "DIMMER" button to dim or brighten lights to the desired level and release, and the

brightness level will be memorized. Turn on the light again, then fan light will restore on

of the brightness level which was dimmed last time.

Note:

This remote controller has memory function setting. The fanwill operate at the same

speed and the fan light will stay at the same brightness as the last time the power

supply was turned off.

Install the transmitter wall bracket in wall by two screws

and hang transmitter in it carefully.

210811