Instructions / Assembly

PAGE: 6 / 9
Fig.10
Safety Cable Hook
Safety
Cable
Hang the safety cable into the safety cable hook.
Move ground wires (a), outlet box wires (b), and motor
wires (c) away from the center of the hanger bracket
as shown. Thread the antenna through the hanger
bracket first, then thread the receiver through the hanger
bracket until it is placed center. Finally, cut motor wires (c)
to length needed for connections.
Fig.8
Antenna
Receiver
Hanger Bracket
a.
c.
b.
Black
Black
Black
Black
Connect the white
wire from receiver
to the white wire
from motor with a
wire connector
Connect the black
wire from receiver
to the black wire
from motor (This is
for fan control) with
a wire connector.
White
White
White
White
Connect the blue wire
from receiver to the
blue wire from motor
(This is for light control)
with a wire connector.
Connect the orange wire from
receiver to the orange wire from
motor (This is for reversible
function) with a wire connector.
Connect the yellow wire
from receiver to the yellow
wire from motor (This is
for reversible function)
with a wire connector.
Connect four ground wires (Green or bare copper)
coming from outlet box, downrod, hanging bracket
and receiver of remote control with a wire connector.
Connect the white (neutral)
wire from receiver to the
white (neutral) wire from
the outlet box with a
wire connector.
Connect the black (hot) wire
from receiver to the black (hot)
wire from outlet box with a wire
connector.
*** After making the wire connections, the wires should be
spread apart. The white (neutral) conductor and green
(grounding) conductor on one side and the black (hot)
conductor, blue (light) conductor, Orange and yellow
conductor on the other side of the outlet box.
*** The wire connection points should be turned upward and
pushed carefully up into outlet box.
Fig.9
Green
Green
Blue
Blue
Orange
Yellow
Yellow
210811