Installation Guide

PAGE: 5 / 8
Installation Steps :
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION IN
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 15.87 lbs (7.2 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Fig.1
Turn OFF the electric circuit at the
main fuse or circuit breaker box.
THE SAFETY
INSTRUCTIONS AND INSTALLATION INSTRUCTIONS. IF IN DOUBT, CONSULT A QUALIFIED
ELECTRICIAN.
Tighten the hanger bracket to the outlet
box with 2 mounting screws. (To reduce
the risk of fire, electric shock, or personal
injury, mount to the outlet box marked
"Acceptable for fan support" and use
mounting screws provided with the outlet
box.)
Note: For slope ceiling installation, make
sure that the chip of the hanger bracket
is toward the floor.
Hanger
Bracket
Fig.3
Outlet Box
Chip
Remove the Lock Pin and take o
ff
the Hanger Pin.
Hanger Pin
Lock Pin
Fig.4
Loosen the collar screws out part way.
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
Slide canopy, canopy cover (Making
Fig.5
Motor Wires
Collar
Downrod
Canopy
Canopy Cover
Downrod Stand
Cover
sure the smooth side of canopy cover
is facing downward.), and downrod
stand cover onto downrod, as shown;
then thread motor wires through
downrod.
Fig.6
Motor Wires
Collar
Tighten the two Collar Screws.
Slide Lock Pin into Hanger
Pin until it is locked into position.
Fig.7
Lock Pin
Collar
Screws
F A N C O
200116
Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.) Attach the safety cable hook to the ceiling and make sure the safety
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Safety Cable Hook
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Fig.2
cable hook is covered by the fan canopy.