Installation Sheet

PAGE: 8 / 10
Fig.20
Fig.21
Install the battery (9V, included) to the transmitter.
* Press "HI" button to turn on the fan at high speed.
* Press "MED" button to turn the fan in medium speed.
* Press "LOW" button to turn the fan in low speed.
* Press "FAN OFF" button to turn off the fan.
* Press "LIGHT ON /OFF" button to turn on or turn off the light.
* Press and hold the "DIMMER" button to dim or brighten lights to the desired level and
release, and the brightness level will be memorized. Turn on the light again, then fan light
will restore on of the brightness level which was dimmed last time.
Note:
This remote controller has memory function setting. The fan will operate at the same
speed and the fan light will stay at the same brightness as the last time the power
supply was turned off.
Install the transmitter wall bracket in wall by two screws
and hang transmitter in it carefully.
Wall Bracket
Screw
Transmitter
HI
MED
LOW
FAN OFF
DIMMERLIGHT
ON/OFF
Fig.19
Turn ON the electric circuit at the
main fuse or circuit breaker box.
Switch Box
Slide Switch
Forward
Slide Switch
Forward
The slide switch on switch box sets direction of fan rotation.
Select the desired direction of fan rotation (Fig.18-b).
Push the slide switch left for " Forward" and right for "Reverse".
Note: Wait for fan to stop before reversing the direction of blade
rotation.
Fig.18-a
Fig.18-b
LED Light Bulb
Shade
Reverse
Reverse
Install LED light bulbs (included) first, then lift the glass and
attach it to the light fixture using the three thumbscrews.
Tighten all three screws securely by hand. (Fig.18-a).
F A N C O
181128