Installation Sheet

PAGE: 7 / 10
Remove the motor screws and washers from the
motor assembly.
Secure Blade Brackets to the motor with washers
and motor screws.
NOTE: Before installing blade brackets to the
motor, please remove the plastic inserts.
Blade Bracket
Motor Screw
Washer
Fig.14
Tighten fan blades to blade brackets by using
washers and blade screws.
Remove one canopy screw (for
later use), then push the canopy
upwards by inserting canopy
screw head left in hanger bracket
into key hole slot, rotate the
canopy till the hole in canopy aligns
the hole in hanger bracket, finally,
secure the canopy to hanger
bracket with previous canopy
screw and tighten the other canopy
screw.
Attach the decorative cap to
canopy,rotate it clockwise until
tight.
Remove one fix screw (for later use), and loosen the other two
fix screws. Thread the wire through the switch box cover, and
then push the switch box cover upwards by inserting the other
two fix screw heads into key hole slots, rotate the switch box
cover till the round hole in switch box cover aligns the hole in
motor assembly, finally, secure the switch box cover to motor
assembly with previous fix screw and tighten the other two fix
screws.
Fig.12
Canopy Screw
Canopy Screw
Key Hole
Slot
Hanger Bracket
Canopy
Decorative Cap
Switch Box
Cover
Key Hole Slot
Round Hole
Fix Screw
Motor
Assembly
Fig.15
Fan Light Installation:
Fan Blade
Washer
Fig.13
Blade Screw
Blade Bracket
WARNING:
This fan light has a built-in current limiting device in the receiver of remote control to conserve energy. The fan light
will not be brighter when you press dimmer button if the combined wattage of the installed bulbs exceeds 190 Watts.
Connect wires :
--- Connect the blue (hot) wire from the switch
box to the black (hot) wire from fan light
with a wire connector.
--- Connect the white (neutral) wire from the
switch box to the white (neutral) wire from
fan light with a wire connector.
Carefully put the wires into the switch box.
Then connect the two terminals respectively
from the motor and the switch box.
Secure the switch box onto switch box cover
with switch box screws.
Switch Box
Screw
Fig.17
Terminals
Wire Connector
Fig.16
Fan Light
Nipple
Switch Box
Hex Nut
Washer
F A N C O
181128
Remove the plug from the switch
box. Attach the fan light to the
switch box by thread the fan light
wires (black and white) and rotate
nipple through the hole of switch
box and then screw them onto the
switch box by nut & lock washer.
Be sure it is tight enough to
prevent light kit from vibrating
loose.