Installation Sheet

PAGE: 8 / 10
Fig.25
Turn ON the electric power at the main fuse
or circuit breaker box.
Restore the cover and the lamp shade back to the
LED pan, and secure them with decorative clips
and bolt nuts.
LED Pan
Housing
Stud
Cover
Set Screws
Key Hole Slot
LED Pan
Screw Hole
Lamp Shade
Decorative Clip
Bolt Nut
The slide switch sets the direction of fan rotation. Select the
direction of fan rotation you need by sliding the switch.
Push the slide switch left for " Forward" and right for "Reverse".
Caution: In the original ex-factory setting, the fan was set
in low speed and the fan light was set in “ON” mode.
Fig.24
Slide Switch
Reverse
Forward
Fig.23
Unscrew a set screw, Attach the LED pan up to the bottom
of the fan by inserting the other two set screw heads into key
hole slots, rotate it to place, then secure the previous
set screw by aligning screw hole and the hole at the bottom
of the fan, tighten the rest two set screws to secure LED pan.
NOTE: While install or remove the LED pan, please keep
the insulation pads intact carefully. Turning the set screws
over-tightly or fast will damage the insulation pads.
Fig.22
Fig.26
Install the battery (9V, not included) to the transmitter.
* Press "HI" to turn on the fan at high speed.
* Press "MED" button to turn the fan in medium speed.
* Press "LOW" button to turn the fan in low speed.
* Press "FAN OFF" button to turn off the fan.
* Press "LIGHT ON /OFF" button to turn on or turn off the light.
* Press and hold the "DIMMER" button to dim or brighten lights to the
desired level and release, and the brightness level will be memorized.
Turn on the light again, then fan light will restore on of the brightness
level which was dimmed last time.
Note:
This remote controller has memory function setting. the fan light will stay
at the same brightness as the last time the power supply was turned off.
HI
MED
LOW
FAN OFF
DIMMERLIGHT
ON/OFF
Fig.27
Install the transmitter wall bracket
in wall by two screws and hang
transmitter in it carefully. (See Fig.27)
Wall Bracket
Screw
Transmitter
F A N C O
171120