Installation Sheet

PAGE: 5 / 10
Installation Steps:
Fig.1
Turn OFF the electric power at the
main fuse or circuit breaker box.
(For downrod mount only):
Loosen the collar screws in part way.
Insert the downrod into the collar. Slide
hanger pin through holes of collar and
downrod.
Fig.5
(For downrod mount only):
Remove the hanger ball screw, then
slide the hanger ball downwards.
Fig.6
(For downrod mount only):
Slide the pin out. Remove the ground Wire
screw. Remove the lock pin and take off
the hanger pin. Remove the hanger ball.
Fig.8
Downrod
Hanger Ball
Screw
Ground
Wire Screw
Hanger Pin
Pin
Lock Pin
Hanger Ball
Collar
Fig.7
Motor Wires
Safety Cable
Downrod
(For downrod mount only):
Thread the motor wires and safety cable
through the downrod.
Fig.3.
Housing
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 18.2 lbs (8.25 kgs). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failing to do so can result in serious injury.
Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.) Attach the safety cable hook to the ceiling with the dry wall screw and
washer, and make sure the safety cable hook is covered by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
Fig.5.
Fig.2.
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Washer
Safety Cable Hook
Dry Wall Screw
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
(For ceiling mount only):
Remove the canopy cover from the canopy.
Remove three of six screws (every other one)
securing the motor collar to the top of the fan
motor housing. Attach the canopy to the housing
with three screws.
(For ceiling mount only):
Raise the fan and place the canopy on the
hanger bracket hook for wiring.
Go to Fig.15 for the next steps.
F A N C O
171120
Fig.4.
Hanger
Bracket
Hook