Installation Guide

PAGE: 6 / 9
Green (Ground)
Fig.8
Make wire connections:
1). The white motor wire to the white wire from the outlet box with a wire nut.
2). The black motor wire to the black (hot) wire from the outlet box
with a wire nut.
3). The green (ground) wire from the downrod and hanger bracket to the ground
wire from the outlet box with a wire nut.
*** After making the wire connections, the wires should be spread apart with the
grounded wires on one side of the outlet box and the ungrounded wires on the
other side of the outlet box.
*** After the connections have been made, the wires should be turned upward and
pushed carefully up into the outlet box.
Hang the safety cable into the safety cable hook.
Fig.10
Canopy Screw
Canopy Screw
Key Hole
Slot
Hanger Bracket
Canopy
Decorative Cap
Remove one canopy
screw (for later use),
then push the canopy
upwards by inserting
canopy screw head
left in hanger bracket
into key hole slot,
rotate the canopy till
the hole in canopy
aligns the hole in
hanger bracket, finally,
secure the canopy to
hanger bracket with
Fig.11 Fig.12
Fig.13
Motor Screw
Washer
Blade Holder
Remove the motor screws and
washers from the motor assembly.
Secure blade holders to the motor
with washers and motor screws.
previous canopy screw and tighten the other canopy
screw. Attach the decorative cap to canopy, rotate it
clockwise until tight.
Decorative Plate
Blade
Rubber
washer
Glass Holder
Set Screw
Blade Screw
Thread the blade screws
through the rubber washer,
blade holder and blade into
the decorative plate. Tighten
all blade screws securely.
Repeat to other blades.
Fig.14
LED
Module
LED Module
Screw
Female terminal
male
terminal
Connect the female terminals from motor to male terminals
from LED module.
secure the LED module to the motor by LED module screws.
Note: 1). The black fixture wire to blue motor wire.
2). The white fixture wire to white motor wire.
Fig.9
Safety Cable Hook
Safety
Cable
Remove one fan motor assembly screw
(for later use), Push the glass holder
upwards until the fan motor assembly
screws insert into the key hole slot of glass
holder then rotate the glass holder till it fixed
on the motor bottom. Finally, secure the
glass holder to motor bottom with previous
screw which we removed and tighten the
other two fan motor assembly screws.
F A N C O
191225